Ring 2 solar charger not charging hey walterromano5.
Ring solar panel troubleshooting.
Due to the covid 19 crisis shipping carriers are seeing an increase in volume and your order may take an additional 24 48 hours to process.
Zero power output zero output is a common problem and in nine out of ten cases it is due to a faulty inverter or charge controller.
If not try another outlet.
I have the ring stick up cam battery and have attached the solar panel and i don t see any way to check if it is actually working.
The wires for the solar panels extend through a hole in the plastic.
Fully close and re open your app.
Slide the mounting plate back into its slot on the back of the spotlight cam until it clicks into place.
Make sure to complete the setup of your spotlight cam in your ring app before installing the super solar panel.
Connect the positive multi lead into the positive lead of the panel through the mc4 connectors then do the same with the negative leads.
Community support is available by phone 3am 11pm at 1 800 656 1918 or via chat 5am 9pm pdt.
It s also possible that one solar panel in your pv array failed.
We have had lots of sun lately so i don t understand and wonder if the panel is even working.
The one you re using may be faulty or associated with a light switch.
On the mounting plate pop the rubber weatherproofing plug out of its hole.
Check to make sure your stick up cam is powered on.
Click here to visit our contact us page for more options.
Restart your router and run through the setup process again.
Ensure the position is strategic for several hours of direct sunlight each day and that there is no debris covering the panel.
The solar panels are adhered to the outside of the sign.
As the pv modules are connected in series one failing pv module will shut down the entire system.
Be careful of the solder where the wires are connected to the panel.
For updated information see our response to covid 19.
The panels need to be peeled off but gently.
Physically installing and connecting your super solar panel to your spotlight cam is a simple process.
I just got a notice my battery is low in the camera.
Remove the rubber plug from the rear of your stick up cam battery.
Follow the step by step guide below for instructions.
Press the button on the back of the spotlight cam and slide the mounting plate out of its slot.
The best thing to check is the amount of light your solar panel is receiving.
Ensure your camera s battery is 100 charged.
