Samsung French Door Refrigerator Not Dispensing Water

To determine if the door switch is defective use a multimeter to test it for continuity.

Samsung french door refrigerator not dispensing water.

The water filter is located in one of the two places below in your refrigerator. Here are the following reasons. Verify the child lock is not turned on this setting may also disable the dispenser. Test solenoid valve coils with meter for continuity.

If the door switch fails the dispenser will not turn on. The most common place to see water is at the bottom of the compartment such as below the vegetable or crisper drawers. This is a modal window. Check if the valve is clogged if so remove clog and inspect valve for other issues.

If the door switch does not have continuity when activated replace it. Check the water filter. Verify neither door is open when trying to dispense if the door is open the keep the dispenser shuts off. Look for a connection point at the bottom or top of the door try removing the hose and blowing air through it and out the dispenser.

If the door switch does not have continuity when activated replace it. This will be difficult to track down. Hold down the energy saver button for a further three seconds to re activate the lock. Water leaks in a samsung refrigerator many times when you see a pool of water or one that froze into a sheet of ice it can often be attributed to condensation or a spill you didn t notice.

If air passes through it s not frozen. The door switch turns off the ice and water dispenser when the refrigerator door is open. Replace the water inlet valve if found to be not in working order. If the water filter is not correctly installed it can block the water flow into the dispenser.

If the refrigerator has been recently installed there may be air in the line. Samsung refrigerators let you lock the water dispenser so kids can t access water without your attention. When your refrigerator does not dispense water. The water inlet valve supplies water to the refrigerator and can be faulty either mechanically or electrically.

If the refrigerator water dispenser is not working the water supply tube in the door may be frozen. Access to the tank is gained by removing all of the shelves and crispers and removing the cover panel in the lower portion of the refrigerator on the rear wall inside the refrigerator. Hold the lever down for up to 5 min until water dispenses and then dispense 2 3 gallons to clear all the remaining air from the line. To determine if the door switch is defective use a multimeter to test it for continuity.

Hold down the energy saver button for three seconds to release the child lock feature. The water tank is only to store the water that is used to dispense at the door.