Also when the set temperature is 35 6 f lower the set temperature by 32 33 8 f.
Samsung french door water not cold.
The water in that tank should be about the same temperature as food in the.
The water reservoir for the in door dispenser is usually in the refrigerator compartment behind the back wall.
If the blade does not spin freely replace the condenser fan motor.
Mine is samsung rf28hmedbsr french door one.
If your refrigerator and freezer are not cold enough follow these steps.
If your samsung refrigerator is not cooling either in the french door fridge or bottom freezer it may be in demo mode and need a reset.
Wait until the inside temperature is cool enough.
I have unplugged the fridge for 9 hours then plugged back.
The reservoir holds about 2 liters of water and should take about 15 minutes to cool down to the refrigerators internal temperature.
If the plug is properly inserted remove the plug and try plugging another item into the same socket.
Remove air in the water line.
Make sure the appliance is plugged in properly if the appliance is not plug properly remove the plug from the socket and then re insert it.
When it comes to your water dispenser you ll want to make sure everything is in working order otherwise it may not dispense properly or your water and ice may taste bad.
Or if your fridge or freezer is not cooling enough you may need more clearance space and to leave the doors shut.
I have checked the milk and it was 15 degrees celcius.
If the water is not cold you have probably use up the water in the refrigerators reservoir.
If the condenser fan motor is not working properly the refrigerator won t cool properly.
You need to flush the water system to remove air bubble inside of the water line.
Samsung refrigerator cooling issues.
Next the cold water line is cooled by the main compartment which is holding steady at 39 degrees and so the compartment isn t cold enough to fully chill that line below 60 degrees.
1 in case of time has not passed enough since water line has been installed or fridge temperature is set too high water can be warm.
It had ice build up i could see ice from both holes on twin cooling panel.
To clear air out of your water line press the water dispenser lever for one or two minutes.
It s also a good idea to check if the water pressure is adequate if ice has become clumped and if child lock is.
Next try turning the fan motor blade by hand.
It has a cold water line that flares out a little to hold 24 oz of water which means that you won t be getting lots of cold water.
For example you should check if the water line is connected correctly and if the water filter is clogged.
To determine if the fan motor is defective first check the fan blade for obstructions.