Samsung Smart Tv Weak Or No Signal Check The Antenna Cable Connection

In some cases if you.

Samsung smart tv weak or no signal check the antenna cable connection.

No digital channels or radio channels found. However when i connected to my indoor antenna it still shows no signal. If i click on the tv option it brings me to tv plus instead of prompting me to scan for over the air channels. Previously it worked fine.

If you still see no signal on your tv screen see the next step below 3 if you have reset the cable or sat box and still have the no signal unplug the cable going from the tv to your cable or sat box remove the hdmi cable or other cables from your cable tv or sat set top box keep the cable unplugged for 2 to 3 minutes. I am trying to hook up an antenna to my samsung 4k hd smart tv. I have an hd flat screen tv and when i turn it on it says no signal. Setup was success with wifi and smart things app from my samsung phone.

It says weak or no signal. 2 please apply the auto tuning and check whether tv is working well. Also when i go to settings and then broadcast the broadcast option is greyed out. Netflix and other aps which runs on internet works perfectly well.

When i go to the source menu there is no source for the antenna. Weak or no signal. You connect the antenna cable to the ant in vhf uhf jack on the back of the tv if your antenna cable ends in bare wire or u hooks you can buy an adaptor that will let you connect it to the ant in jack. Check the antenna cable connection run auto progream menu channel.

On the screen the message is. Please let me check that. I have not seen this before as my cable box is connected and turned on. Adaptors are available at electronics stores.

Have you tried to power reset your tv unplugging the power for 1 2 minutes then plugging it back in. A no signal no source or no input message will appear on your tv screen if the tv is not receiving a signal from your tv box. The samsung tv will not turn on. Hi samsung team i recently purchased a samsung tv qe55q6fna.

2 run auto program menu channel. This is often a result of either the tv box being powered off not being properly connected to the tv or the tv being set to the wrong input. 1 connect the rf cable wire into the coaxial cable port of your cable box satellite receiver. Steps to auto tune.

1 check antenna cable connection. I read more. I do not know if.