Check the screen on the inlet hoses on the back of the washer and clean them if there are any obstructions.
Samsung washing machine stopped during rinse door locked.
The door lock secures the washer door shut during operation.
Close the door firmly select the desired cycle and then press the start pause button to start the washer.
It may take a few minutes for the washing machine to cool down and for the lock to release.
Inspect the door lock for damage.
If your samsung front load washer door does not open after a wash cycle completes and no water is inside the tub you may have a faulty door lock assembly bad wiring to and from the door lock assembly a cracked or loose door door lock assembly that causes the washer door to not operate properly a faulty control board bent washer door hinges or faulty control board wiring.
Samsung washer door is locked your washer door locks to prevent water from coming out especially for front load models.
Once the washer door is closed the washer can begin operating.
Door locked during the entire wash cycle the samsung washing machine locks the door to prevent it from being opened and interrupting or stopping the cycle.
If the washer door is not latched shut the door switch prevents the washer from operating.
The door lock can fail either mechanically or electrically.
Washer leaks during rinse cycle problem.
Once the water is gone the door will unlock.
If the door lock is defective the washer may stop mid cycle.
If you get stuck though you can drain the water from front load washers using the emergency drain hose.
Verify the debris filter is clean.
Most washers will have a manual release to unlock the mechanism and allow you to open the door or lid.
Sometimes i get a full wash with no issues and then other times it stops and i have to turn the machine off and reset to rinse spin to get it to finish.
Samsung ecobubble 9kg which is just coming up on 2 years old keeps stopping mid wash.
To fix a washing machine that stops mid cycle try a master reset by first unplugging the washing machine to reset the computer.
After 1 minute plug your machine back in then open and close the door 6 times in 12 seconds to signal the computer to reset.
No debris issues no hose issues.
If the door or lid won t open at the end of the cycle then the lock mechanism may be at fault.
Washer leaks water during the rinse cycle even after cleaning the lint trap and checking water hoses for leaks.
Most of the samsung washers has door lock with feedback its a tiny switch inside the door lock.
Child lock also will lock the door on some models like front loaders.
If a leak is going to happen with a front loader it is most often during the rinse cycle because more water is used at that time.
Verify the water supply valves are completely open.
